Page 57 - Zusammengefügt

CV-Table

S = Default, A = Analog operation usable
CV Description S A Range Note
1 Loco address 3 L 1 – 127 if CV 29 Bit 5 = 0 (automatically reset)
2 Starting voltage 2 0 – 255 CV 2 x (1/255 track voltage)
3 Acceleration time 10 √ 0 – 255 CV 3 x 2ms x (1/255 track voltage)
4 Braking time 10 √ 0 – 255 CV 4 x 2ms x (1/255 track voltage)
5 Top speed 200 √ 0 – 255 CV 5 x (1/255 track voltage)

6 Mid speed 50 0 – 255 CV 6 x (1/255 track voltage)
7 Software version – – read only (10 = 1.0)
7 Decoder reset functions
11 basic settings (CV 1,11-13,17-19,29-119)
16 programming lock (CV 15/16)
6 ranges available 22 light outputs (CV50-59)
33 function outputs (CV 1x0-1x4)
44 engine functions (CV2-6,9,10,54-25,60-66)
66 servo functions (CV 1x5-1x9)
8 Manufacturer ID 160 – read only
0 = 16 kHz
1 = 2 kHz
9 Engine frequency 0 √ 0 – 4 2 = 250 Hz
3 = 60 Hz
4 = 100 kHz
7+8 Register programming mode
CV 7/8 don’t changes his real value
Reg8 = CV-Address CV 8 write first with cv-number, then CV 7
Reg7 = CV-Value write with value or read
(e.g.: CV 49 should have 3)
➔ CV 8 = 49, CV 7 = 3 writing
11 Analog timeout 30 30 – 255 1ms each value
13 Function outputs in analog mode √ add the values to the desired function!
(on if value is set) A1 = 1, A2 = 2, A3 = 4, A4 = 8,
3 0 – 255 A5 = 16, A6 = 32

15 Programming lock (key) 205 0 – 255 to lock only change this value
16 Programming lock (lock) 205 0 – 255 changes in CV 16 will change CV 15
17 Long loco address (high) 128 L 128 – activ only if CV 29 Bit 5 = 1
18 Long loco address (low) 10239 (automatically set if change CV 17/18)
19 Multi traction address 0 L 1 – loco address for multi traction
127/255 +128 = invers direction

41 DRIVE-M